Recoil mods matter
If you pull the slide off almost any modern striker-fired pistol today, you will find a captured recoil spring assembly sitting under the barrel. The spring is held firmly in place on a polymer guide rod by a small screw or a molded plastic flange at the front. From a purely administrative standpoint, a captured spring is a great design. When you field strip the gun for basic cleaning, the spring stays neatly contained on the rod. You don't have to fight the heavy tension of the steel coil to get it seated back against the barrel lug.
But if you look at the guns being built for competition shooting or high-level range work, builders almost universally throw the factory captured systems in the trash. They swap them out for a solid metal guide rod and a loose, uncaptured spring. That switch isn't about aesthetics; it is about taking direct control over the reciprocating mass of the slide and tuning the exact compression rate of the spring steel.
The springs used on factory captured guide rods are usually flat-wire springs. The steel wire is rolled flat like a ribbon instead of being left round. Flat-wire springs are excellent for mass production because they have a very short solid height. This means when the spring is completely compressed, the coils pack very tightly together, taking up very little physical space inside the slide. However, flat-wire springs have a very stubborn, linear compression curve, and they are incredibly difficult to manufacture in precise, granular weight increments. If your gun is oversprung and ejecting weak brass, you generally can't just buy a factory flat-wire spring that is exactly one pound lighter. You are stuck with the factory specification.
Switching to an uncaptured system allows you to run traditional round-wire springs. Because the spring isn't permanently glued or screwed to the rod, you can swap it out in seconds. Round-wire springs are heavily standardized across the industry. You can buy a calibration pack that gives you springs in exact one-pound increments, from a heavy 15-pound spring all the way down to an incredibly light 11-pound spring.
This allows you to perfectly match the mechanical resistance of the slide to the specific power factor of the ammunition you are shooting. If you load light, soft-shooting target ammo, you drop in a 12-pound spring so the slide has enough momentum to easily cycle the brass. If you run heavy defensive loads, you bump it up to a 15-pound spring to prevent the slide from battering the frame.
The guide rod itself also provides a massive mechanical advantage. A factory polymer guide rod weighs virtually nothing. An aftermarket uncaptured rod made from solid stainless steel or dense tungsten adds a significant chunk of static weight to the very front of the pistol frame. That non-reciprocating mass acts as a passive dampener, physically holding the muzzle down against the leverage of recoil. When I want to tune the slide velocity on a new pistol build, I source my solid guide rods and uncaptured calibration springs from https://www.brownells.com/gun-parts/handgun-parts/handgun-recoil-parts/ to get the math exactly right. Ditch the convenience of the captured plastic rod, tune the spring weight to your ammo, and use the steel mass to keep the gun shooting flat.