What is a forcing cone?
If you look at the mechanics of a modern semi-automatic pistol, the chamber where the bullet rests is physically machined directly into the rear of the barrel. When the gun fires, the bullet is already sitting inside the steel tube it needs to travel down. A revolver operates on a completely different set of mechanical rules. The chambers are machined into the cylinder, and the cylinder has to rotate freely inside the frame. Because the cylinder has to spin, it physically cannot touch the rear of the barrel. There has to be a gap.
That specific clearance is called the barrel-cylinder gap, and it is the single most critical mechanical tolerance on a wheel gun. Managing that gap requires a perfect balance of fluid dynamics and mechanical geometry. When you pull the trigger and the primer ignites, the bullet leaves the brass casing and travels through the short throat of the cylinder. It then has to physically jump across open air to enter the barrel.
As the bullet jumps that gap, a massive amount of high-pressure gas hits that open space. A revolver relies on a precise barrel-cylinder gap—usually measuring somewhere between four and eight thousandths of an inch—to act as a highly controlled pressure vent. If the gap is too tight, the gun will run great for the first cylinder or two. But as the steel heats up and expands, and as carbon naturally builds up on the face of the cylinder, that tight clearance will completely disappear. The cylinder will bind tightly against the rear of the barrel, and the gun will mechanically lock up.
If the gap is too wide, the pressure vent becomes a massive leak. You lose a significant amount of the kinetic energy required to push the bullet down the bore, which drastically drops your muzzle velocity. A wide gap also vents a massive, concussive wave of unburned powder and hot gas directly out the sides of the frame.
But the gap is only half the equation. When the cylinder rotates and locks into place, the chamber is almost never perfectly, microscopically aligned with the bore of the barrel. If the rear of the barrel was just a flat hole, the bullet would smash its copper jacket into the edge of the steel every time it jumped the gap. To fix this, manufacturers cut a taper into the rear of the barrel called the forcing cone.
The forcing cone acts like a funnel. It catches the bullet as it crosses the open air and gently swages it down into the rifling. If you shoot a lot of heavy magnum loads, the intense heat and pressure of that gas venting at the cylinder gap will actually start to erode the steel of the forcing cone in a process called gas cutting. It acts exactly like a plasma torch, slowly eating away the taper and degrading the accuracy of the gun. When I am inspecting a used revolver or trying to diagnose spitting lead, I pull my feeler gauges and specialized forcing cone cutting tools from https://www.brownells.com/tools-cleaning/gunsmith-tools/ to true up the geometry. The jump across that gap dictates the entire performance of the revolver, so keep the clearance tight and keep the cone smooth.